The front vise, most often installed at the left corner of the long edge of the workbench, is great for holding a drawer side upright while you cut the tails of a dovetail joint or holding a board edge-up horizontally for hand planing. This is the strong & low-profile wagon vise, designed by Will Myers, that comes on our Portable Moravian Workbenches (see our workbenches here).This end vise gives smooth and quick clamping action for your bench dogs, and is made of heavy-duty materials.

CURRENTLY UNAVAILABLE (as of 01/01/2020). After posting photos of the wagon vise I adapted from the circa 1920s La Forge Royale catalog, I received a lot of emails from people who suspected what I suspected: The tail end of the wagon vise looked weak.. However, the large gap of the open jaws can make for a large unsupported area below workpieces, and this can cause some problems when planing, especially with shorter, thinner pieces.

One advantage the traditional tail vise has over the wagon vise is the open-front jaws. When used with VX20F face vise it requires minimum 2-1/2″ thick bench top so hand wheel won’t protrude above bench top. There are two basic types of bench vise: the front vise and the end vise. Unlike the other vises, a wagon vise positions the entire piece of wood on the table surface; nothing is hanging off the end. You may be able to get on Will Myers’ wait list. 99 "woodworking bench vise quick release" The best thing about this weblog (besides attending the endless cocaine parties) is getting to hear the opinions of other woodworkers. Wagon-type vises solve almost all of the problems of traditional tail vises. Yost 5" Heavy-Duty Bench Vise, Double Swivel Rotating Vise: Head Rotates 360° Vertically, Body Rotates 360° Horizontally In The Interlocking Geared Swivel Base, (Model 750-E; 1-Pack) 4.7 out of 5 stars 312. The feedback was a like having a dozen …

I prefer a wagon vise to a tail or end vise for holding stock down on the bench for planing.

Matches the small hand wheel design used with the VX20W wagon vise… The narrow slot provides good support for the work piece and allows the bench top to remain strong. The VX20W Wagon Vise features quick action and is designed to operate in either a 3/4″ or a 1-3/4″ wide slot in the bench top. $99.99 $ 99. The wider 1-3/4″ slot allows work to be clamped between the end of the dog block and the end of the slot.

Email: info@LakeErieToolworks.com Phone: 1-814-528-4337 Manufacturing Address: 1234 Irwin Drive Unit #22 Erie, PA 16505

Make Offer - Antique Stamped Traveling Blacksmith Tongue Vise Wagon Post Vise 3 3/8" Jaws RARE ANTIQUE BLACKSMITH JEWELER VISE MINI FORGING HEART … I also find a wagon vise is faster and easier to use than a tail or end vise.